To be able to use the PXI you need to add software through NI MAX.įollow this link to learn how to add software. Your PXI have now a PXI running with LabVIEW Real-Time through Phar Lap, but there is no "software" running. This can be done by right-clicking the "Remote systems" tab and click "Create new" and following the steps. After you have formatted and configured your PXI Your PXI should now boot up Labview RT successfully on the PXI short after reboot. If you modified the boot order, return the internal hard drive to the first priority.Ĩ. While rebooting Press the key to access the BIOS. Remove the USB drive and select 9, "Reboot the system."ħ. Press any key to return to the main menu. The PXI controller will go through the reformat and will provide the following message to indicate that the controller has been successfully formatted.Ħ. The Reliance file system also supports disk sizes up to 2TB and file sizes up to 4GB.ĥ. It's recommended that you choose Reliance since the Reliance file system is a transactional file system designed for use in embedded systems to preserve data in the event of a power loss. Select between the FAT32 or Reliance file system to format the controller. Format hard disk and choose alternative 2, "Erase all partitions and create a single new partition".ģ. ĭo not remove the USB drive from the PXI before you are done with this tutorial.Ģ. When powered on press the key continuously during boot and select the USB boot device and click. Plug the USB drive in the PXI and power the PXI ON. If you don’t securely remove your USB device, the files may become corrupt or disappear.įormatting and configuring the PXI with the USB boot device.ġ. Congratulations! You have now made a USB boot device with Phar Lap ETS and LabVIEW RT on it, and the only thing you need to do now is securely remove it from your computer as shown in the picture below. Remember that if the USB drive is not clean/empty, this configuration will delete all the existing files on it.ħ. Select the USB drive you want to format and make into a USB booting device.Ħ. In my case only "Version 2018" showed so I selected and then clicked OK.ĥ. Click "yes" or "okay" on any boxes which pops up until you get this picture.Ĥ. Open NI MAX and in the option bar in the top left corner, choose "Tools" and then click "Create desktop PC utility USB drive"ģ. Get a clean USB memory drive and plug it into your computer.ĭo not remove the USB drive from the computer before you are done with this tutorial.Ģ. 1x USB memory device 1x PXI 1x Computer with NI MAX 1x Computer monitor for PXI 1x USB keyboard for PXI Formatting and configuring your PXI Configuring the USB boot deviceġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |